TM 5-3610-253-14
MAINTENANCE PROCEDURES.
a. This section contains instructions covering direct/general support maintenance
functions for the paper cutter. Personnel required are listed only if the task
requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that the equipment is properly functioning.
INDEX
PARAGRAPH
PROCEDURE
Test Cutting Buttons (S28a and b). . . . . . . . . . . . . . . . . . . 5-40.1
Test Light Barrier Outputs/Inputs . . . . . . . . . . . . . . . . . . 5-40.2
Test Safety Bolt Proximity Switches (SB.A and SB.E) . . . . . . . . . 5-40.3
Test Output of HK Board to Safety Bolt (Y.SB). . . . . . . . . . . . . 5-40.4
Test Gear Limit Switches (S22a and b). . . . . . . . . . . . . . . . . 5-40.5
Test Clamp Proximity Switch (b29). . . . . . . . . . . . . . . . . . . 5-40.6
Test Clamp Foot Pedal Switch (S309). . . . . . . . . . . . . . . . . . 5-40.7
Test Solenoid Y315, (Locking Valve). . . . . . . . . . . . . . . . . . 5-40.8
Test Solenoid Y27, (Clamp Ball Valve) . . . . . . . . . . . . . . . . 5-40.9
Test Solenoid Y33, (Cutting Ball Valve). . . . . . . . . . . . . . . . 5-40.10
Test IAR Circuit Board for Input Power . . . . . . . . . . . . . . . . 5-40.11
Test HK Circuit Board for Input Power . . . . . . . . . . . . . . . . 5-40.12
Test Knife Changing Switch (S340). . . . . . . . . . . . . . . . . . . 5-40.13
Test KK Circuit Board for Input Power . . . . . . . . . . . . . . . . 5-40.14
Test AR Circuit Board for Input Power . . . . . . . . . . . . . . . . 5-40.15
Test Inputs and Outputs of MC Unit Plug Connectors . . . . . . . . . . 5-40.16
Check Clearance Between Knife and Clamp . . . . . . . . . . . . . . . 5-40.17
Replace P1 Block. . . . . . . . . . . . . . . . . . . . . . . . . . .5-40.18
Replace P2 Block. . . . . . . . . . . . . . . . . . . . . . . . . . . 5-40.19
Replace Locking Valve M1 or Clamping Valve M2 . . . . . . . . . . . . 5-40.20
5-499