TM 5-3610-253-14
e.
Loosen four motor mounting bolts and slide motor back to loosen V-belt.
Remove defective V-belt.
Install new V-belt. Pull against motor to tighten V-belt until it has
f.
6 - 9 mm (1/4 - 3/8 in.) deflection when pressed. Tighten motor
mounting bolts.
Reinstall brake and secure with four nuts.
g.
Reconnect brake coil wires to terminal block.
h.
Reinstall V-belt cover.
i.
Place operator key back into safety lock.
j.
Replace Backgauge Motor.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: 7 mm Nut Driver
10 mm Combination Wrench
13 mm Combination Wrench
SUPPLIES: Backgauge Motor
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a. Turn off power.
(1) Turn main power switch to 0 position.
(2) Using operator key, lock safety lock and keep key in your
b. Remove nuts and V-belt cover.
5-154