TM 5-3610-253-14
Table 5-8. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. MACHINE DOES NOT CUT THROUGH MATERIAL - Cont
Check main motor V-belts for oil.
Step 4.
(a) If belt is contaminated with oil, repair oil leak and replace
V-belts (paragraph 5-16.4) and refer to direct/general
support maintenance for correction of class III oil leak.
(b) If not, proceed to step 5.
Step 5. Check for oil on brake and clutch linings.
(a) If contaminated, clean clutch and brake linings and check
hydraulic components and connections for leaks.
(b) If leaks are present, refer to direct/general support
maintenance for repair of class III leakage.
(c) If not replace clutch and/or brake linings (paragraph
2. BOTTOM SHEET OF MATERIAL IS CUT ONLY ON ONE SIDE OR NOT AT ALL.
Check that the knife is not parallel to the table.
Correct for proper parallel cut as follows:
