TM 5-3610-253-14
Table 5-8. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. BOTTOM SHEET OF MATERIAL IS CUT ONLY ON ONE SIDE OR NOT AT ALL - Cont
(d) Remove the eccentric cover.
(e) Loosen the locknuts on the turnbuckle.
(f) Turn the turnbuckle 1/4 of a turn and then make a cut.
Continue to repeat steps (a) through (f) until problem is
corrected.
(g) Tighten turnbuckle locknuts, and reinstall eccentric cover.
3.
OVER CUT DURING THE CUT.