TM 5-6675-323-14
e.
Illuminate
viewing
stages.
(1) Turn on fan motor control switch.
(2)
Turn
on
left
and
right
illumination
controls.
(3) Turn illumination controls fully on (maximum intensity) and allow 15
m i n u t e s for lamps to warm up.
f.
Completion
of
task.
(1) Turn illumination controls off.
CAUTION
W a i t 2 or 3 minutes before turning fan motor off to prevent damage to
equipment.
(2) Fully rewind film on supply reel and remove reel from microscan.
(3) Place one hand under empty film reels, and release spindle locking knobs
with other hand to release spindle.
(4) Remove and empty film reels for reuse as take-up reels.
(5) Turn fan motor control switch off.
(6) Unplug power cord.
(7) Cover microscan with dust cover.
(8) Unlock door lock to lower table into well and close door.
5-6.3 Preparation For Movement.
Raise leaf and lock onto door.
a.
b. Remove dust cover.
c.
Remove reel brackets and store in container.
d.
Remove stereoscope and store in container.
e.
Lift microscan from turntable and store in container.
This equipment is designed for operation
5 - 7 . OPERATION UNDER UNUSUAL CONDITIONS.
only in a controlled environment.
5-22
