TM 5-6675-323-14
Section IV ORGANIZATIONAL MAINTENANCE
This equipment does not require lubrication at
LUBRICATION INSTRUCTIONS.
5-11.
this level of maintenance.
5 - 1 2 . REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
F o r authorized common tools and equipment,
5-12.1 Common Tools and Equipment.
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5 - 1 2 . 2 Special Tools: Test, Measurement, and Diagnostic Equipment: and Support
S p e c i a l Tools, TMDE, and Support Equipment is listed in the applicable
Equipment.
repair parts and special tools list and in Apppendix B of this manual.
5-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
a n d Special Tools List, TM 5-6675-323-24P covering organizational maintenance for
this equipment.
SERVICE UPON RECEIPT.
5-13.
5-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c.
C h e c k to see whether the equipment has been modified.
5-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are no
organizational PMCS assigned for this equipment.
5-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
a. Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level.
Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available. Trou-
bleshooting procedures used by the operator should be conducted in addition to the
organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action.
If a malfunction is not listed or is not
corrected by a listed corrective action, notify your supervisor.
c. For unidentified malfunctions, use the following schematic or the foldout
located at the end of this manual for further fault analysis.
5-26
