TM 5-6675-323-14
(4) If two films are to be mounted, repeat steps (1) through (3) for other
side.
b. Thread film.
(1) Bring film under rear roller into slot between bottom cover and rollers.
Feed film until end comes out over rollers at front of microscan.
T h e n feed film
under rollers at rear of equipment and up to take-up spool.
(2) Wind film on take-up reel and tighten drag brake to adjust film tension.
(3) Repeat steps (1) and (2) for second reel.
c.
Install
stereoscope.
NOTE
When a higher viewing distance is required, the 8 in. post is available
and may be used. T h e 8 i n . p o s t i s i n t e r c h a n g e a b l e w i t h t h e 5 . 2 5 i n .
post . T h e 8 in. viewing post, however, prevents the microscan from being
stored inside the desk well.
(1) Mount stereoscope.
F o l l o w procedures in Chapter 7 to assemble
r h o m b o i d to pod.
5-20
