TM 5-6675-323-14
(2) Lock table to door.
(3) Place microscan on turntable so that feet rest in depressions.
(4) Plug in power cord.
(5) Move red lever to rotate microscan.
NOTE
Lever locks when it contacts pin and must be pushed to left to unlock.
Pin acts as motion stop to prevent complete rotation of turntable.
c.
Install film reel brackets.
(1) Hook lipped edge of base on idler bracket over top of rail.
(2) Lower bracket so stud enters center hole.
(3) Press snap slide fastener to left to lock stud.
(4) Slide reel brackets on rail.
(5) Position reel brackets on rail.
Then tighten clamping knob.
5-18
