TM 5-6675-318-14
(7) When END is displayed, press the clear (C) key.
(8) Rewind the tape by entering code 49, then remove the cassette.
NOTE
During the performance of the next procedure, if RSET NO is displayed,
press the enter (E) key.
(9) If more data is to be processed, install the next cassette, and repeat
steps (4) through (8) above until all tapes for that site are processed.
(10) Display the translocation position by entering code 73 (Table 4-8, page
4-72) and record the position on DA Form 1959.
(11) If all data has been processed, perform your after PMCS, Table 4-1.
Table 4-15. CODE 39 DISPLAYS FOR TRANSLOCATING FROM 2-SITE TAPE
This code is operative only in the off-line mode. The tape must have been recorded
on a remote MX 1502 in the remote mode that received data via a communications link
from a control MX 1502 at another site.
Enter code 39 to read satellite and modem data from tape and compute 3D and
translocation positions. When code 39 is entered, the MX 1502 asks the user how
many satellite passes to process.
I n i t i a l D i s p l ay
Enter either no number, one number, or two numbers. Entering no number causes all
passes at the site to be processed. Entering one number indicates the number of
passes to process in the computations.
Process Eight Passes
4-96 Change 2
