TM 5-3610-287-24
2-60.
REPAIR WALL HEATER (CONT)
Remove screws (4) and partially remove interior assembly (5).
4.
Disconnect wires (6) leading from fan motor (7) on element
5.
assembly (8).
6.
Remove retaining nut (9) and fan blade (10).
7.
Remove screws (11), starwashers, rubber grommets (12), and fan
motor (7).
8.
Install new fan motor (7) with rubber grommets (12), starwashers, and
screws (11).
9.
Install fan blade (10) with retaining nut (9).
10.
Connect wires (6) to element assembly (8).
11.
Install interior assembly (5) with screws (4).
12.
Install grill (3) with screws (2).
13.
Install control knob (1).
14.
Set HEATER circuit breaker to ON.
15.
Test operate wall heater by turning control knob to right.
Power cable
Expanding side power cable is repaired by replacing a.
connector b. Power cable
POWER CABLE CONNECTOR
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Soldering gun
Flat-tip screwdriver
Materials/Parts
Power cable connector, MS31088-28-20P (curbside)
Power cable connector, MS31088-22-23P (roadside)
Masking tape (appendix C, item 29)
Lead pencil (appendix C, item 13)
Electrical tape (appendix C, item 28)
2-191
