TM 5-3610-287-24
2-61.
REPAIR EXPANDING SIDE POWER CABLE (CONT)
Remove screws (7) and lockwashers.
6.
Separate each section of connector
housing (6).
7.
Remove wire covering (8). Tag and desolder wires (9) from terminal
pin assembly (10). Remove pin assembly (10).
Remove seal (5) and strain relief clamp (4).
8.
9.
Install new strain relief clamp (4) and new seal (5) on cable (1).
10.
Solder wires (9) to new pin assembly (10) and install new wire
covering (8).
Place new connector housing (6) over new pin assembly (10) and install
11.
with screws (7) and lockwashers.
Install strain relief clamp (4) on connector housing (6).
12.
13.
Install screws (3) and lockwashers on strain relief clamp (4).
WARNING
ELECTRICAL HAZARD. Turn off MAIN POWER switch before
connecting or disconnecting expanding side power cable.
Failure to do so may result in death or serious injury.
14.
Set MAIN POWER switch to OFF.
Connect expanding side cable (1) on wall receptacle (2).
15.
16.
Set MAIN POWER switch to ON.
17.
To test operate, set all expanding side circuit breakers to ON and
operate equipment.
POWER CABLE
INITIAL, SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Solder gun
Solder
Flat-tip screwdriver
Extension light
2-193
