TM 5-3610-287-24
2-52.
REPAIR BLACKOUT LIGHT SYSTEM (CONT)
5.
Remove screws (7) and marker light (5) from blackout light assembly.
Cut wire (8) above connector (9).
6.
7.
Connect wire from new marker light (5) to blackout light assembly wire
(8) with new wire nut (10).
8.
Install marker light (5) with screws (7).
9.
Install light bulbs (6) by pushing in and turning.
10.
Gently snap lens (4) onto marker light (5).
Position foam gasket (3) on blackout light cover (2) and align holes.
11.
12.
Install blackout light cover (2) with thumbscrews (1).
13.
To test operate blackout light system, set BLACKOUT LIGHTS switch to
ON (up) position. Then set BLACKOUT BYPASS switch to OFF (down)
position and open personnel door.
DOOR SWITCH
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Flat-tip screwdriver
Extension light
Pliers
Crimping tool (appendix B, section III, item 14)
Materials/Parts
Switch, 4030
Electrical splice, NAS1388-2
2-165
