TM 5-3610-287-24
2-53.
REPLACE DOME LIGHT ASSEMBLY (CONT)
WARNING
before replacing dome light assembly. Failure to observe
this warning may result in death or serious injury.
2.
Remove screws (1) securing dome light assembly (2) to ceiling and allow
dome light assembly to hang by wire (3).
3.
Cut wire (3) above connector (4) and remove dome light assembly (2).
INSTALLATION
1. Connect wire (3) to new dome light assembly (2) with wire nut (5).
2.
Install dome light assembly (2) to ceiling with screws (1).
3.
Connect 12-volt dc power source to Section and test operate dome light
assembly.
Fluorescent lights are repaired by replacing: a. Ballast
b. Diffuser panel
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Flat-tip screwdriver
Wire cutter
Socket wrench set
Extension light
Materials/Parts
Wire nuts, 2978 (2 required)
Wire ties, 230425N (2 required)
2-170