TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
b.
Prepare Paper Cycle (Cont)
(o) Aline sheet stops (5) parallel to and 1/64 in. (0.08 cm) away
from rear edge of paper pile.
Allow plastic weights (6) to rest lightly on
top of paper pile.
(p) Tighten thumbscrews (4).
(q) Loosen socket head screws (7) and
with groove in guide rail (9). Use indicator
in same manner.
(r) Tighten socket head screws (7).
aline lifting suckers (8)
marks to adjust both suckers
NOTE
Distance from bottom of lifting suckers to top of
paper pile can be adjusted while Printing Press is
running.
Maximum distance should be maintained to
prevent feeding two sheets at a time.
(s) Set lifting sucker height adjustment knob (10) at midway point.
(t) Turn knurled adjustment ring (1) to raise or lower air tubes
(2) 1/8 to 3/16 in. (0.33 to 0.48 cm) below top of paper pile to separate
top 6 to 10 sheets of paper pile.
2-35
