TM 5-3610-286-10
2-7.
OPERATING PROCEDURES
b.
Prepare Paper Cycle
(CONT)
(Cont)
NOTE
Sheet separation springs may be used instead of
brushes.
They are positioned in same manner.
(1) Loosen lockscrews (1), extend sheet separation brushes (2)
1/16 to 3/16 in. (0.15 to 0.48 cm) onto paper pile, and angle toward
suction head (3).
Set sheet separation brushes (2) to apply light pressure
on paper pile.
(m) Tighten lockscrews (1).
(n) Loosen thumbscrews (4) and slide sheet stops
point 2 to 4 in. (5.1 to 10.2 cm) in from edge of sheet.
(5) laterally to a
2-34
