TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
b.
Prepare Paper Cycle (Cont)
(a) Install feeder pile board (1) between side rails (2).
(b) Insert pin wrench into knurled knob (3) and turn to left to
unlock guide rail (4).
(c) Move guide rail (4) laterally and center between two split
pins (5).
(d) Turn knurled knob (3) to right to lock into position.
(e) Insert two wooden rear spacers (6) between guide rail (4) and
feeder pile board (1) to prevent shifting.
(f) Measure sheet of paper.
(g) Locate upper scale (7) and operator side standard hand-
wheel (8).
Using handwheel, position operator side standard (9) on scale
that matches sheet size.
(h) Place sheet on feeder pile board (1) flush against front and
side of operator side standard (9).
(i) Turn drive side standard handwheel (10) and move drive side
standard (11) to within 1/16 inch of sheet edge on drive side.
(j) Remove sheet and position front spacers evenly between side
standards and center space.
NOTE
l Check stock for imperfections and foreign
material.
l If not in nonstop feed mode, leave nonstop feeder
bar off.
(k) Remove nonstop feeder bar.
NOTE
Wedges can be used to level paper pile.
(l) Prepare and load stock.
2-31
