TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
b.
Prepare Paper Cycle (Cont)
(b) Tighten locking handle (1).
(c) Turn star-shaped handle (3) on top of suction head (2) to left
to move suction head to its lowest position.
(d) Pull feeder handwheel (4) outward and turn to right until
governor foot (5) is at its highest
(e) Set AUXILIARY PILE/MAIN
position.
(f) Take Printing Press off
position.
PILE selector switch (6) to MAIN PILE
safe.
Press and hold main pile up
pushbutton (7) to raise paper pile until it stops at transfer switch (8).
(g) To raise paper pile automatically, turn feeder handwheel to
left until governor foot (5) is in its lowest position.
(h) Loosen locking handle (1) and move suction head (2) until red
mark on governor foot (5) is alined with rear edge of paper pile.
(i) Tighten locking handle (1).
(j) Turn feeder handwheel (4) to left until front flaps (9) are in
vertical position and governor foot (5) is in its lowest position.
Push in
feeder handwheel (4) to disengage.
(k) Turn star-shaped handle (3) on top of suction head (2) to right
until paper pile rises to a point 3/16 to 5/16 in. (0.48 to 0.79 cm) below
top of front flaps (9).
Put Printing Press on safe.
2-33
