Section III.
OPERATION UNDER
INDEX
Para
TM 5-3610-286-10
USUAL CONDITIONS
Para
Assembly and Preparation for
Remove Plate
. . . . . . . .
2-7h
Use
. . . . . . . . . . . . . . . . .
2-6
Drain Dampening
Operating Procedures
. . . . .
2-7
Assembly
. . . . . . . . . . .
2-7i
Perform Before Operation
Operation of Auxiliary
PMCS . . . . . . . . . .
2-7a
Equipment
. . . . . . . . . . . .
2-8
Prepare Paper Cycle
. . . . . . 2-7b
Plate Register Punch
. . . . . . 2-8a
Prepare Cylinder
Nonstop Feeder
. . . . . . . .
2-8b
Assembly
. . . . . . . . . . . .
2-7c
Continuous Delivery . . . . . . . 2-8c
Prepare Dampening
Packing Gage
. . . . . . .
2-8d
Assembly
. . . . . . . . . . 2-7d
Preparation for Movement . . . . 2-9
Prepare Inking
Feeder End
. . . . . . . . .
2-9a
Assembly
. . . . . . . . . . .
2-7e
Operator Side
. . . . . . . .
2-9b
Make-Ready Procedures . . . .
2-7f
Delivery End
. . . . . . .
2-9c
Perform Washup
TSS Press Section
. . . . . . 2-9d
Procedure
. . . . . . . . . .
2-7g
2-6.
ASSEMBLY AND PREPARATION FOR USE.
The Topographic Support System
Press Section Printing Press does not require unpackaging, assembly, or
installation instructions other than those covered in TM 5-3610-287-10,
Operators Maintenance Manual for Topographic Support System Press Section.
2-7.
OPERATING PROCEDURES
a. Perform Before Operation PMCS (Table 2-1)
b.
Prepare Paper Cycle
INITIAL SETUP
Tools
0.10 mm Feeler gage (appendix B, section III, item 12)
Yardstick/meterstick (appendix D, item 67)
Curved pin wrench (appendix B, section III, item 41)
5 mm Hex key (appendix B, section III, item 20)
Long-handle flat-tip screwdriver (appendix B, section III, item 32)
U-shape special wrench (appendix B, section III, item 46)
Suction air adjustment key (appendix B, section III, item 21)
Materials
Map paper (appendix D, item 42)
2-29