TM 5-3610-286-10
2-7.
e.
OPERATING PROCEDURES (CONT)
Prepare Inking Assembly (Cent)
(a) Take Printing Press off safe and inch until oscillator rollers
no. 5, no. 6, no. 14, and no. 17 are centered. They should protrude 3/8
in. (10 mm) from the ends of the rollers they contact.
NOTE
Centering pivot bolt (1) in inner ring (2) on scale
provides no oscillation.
Moving pivot bolt (1) to
outer ring (3) provides maximum oscillation.
(b) Put Printing Press on safe.
Loosen hex-head nut (4) with
T-handle wrench, and slide pivot bolt (1) to desired setting.
(c) Tighten hex-head nut (4).
2-92
