TM 5-3610-253-14
Table 5-21.
ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
18. MAIN MOTOR WILL NOT START - Cont
(b)
If readings are incorrect, replace main drive motor
(c)
If correct, replace cabling between overload relay and main
drive motor.
19. BACKGAUGE DOES NOT TRAVEL ALL THE WAY FORWARD OR BACKWARD.
Be sure that backgauge sledge cams and limit switches are
Step 1.
positioned correctly and are not loose.
(a) If switches are out of adjustment, adjust backgauge
limit switches (paragraph 5-36.17).
(b) If switches are adjusted correctly proceed to step 2.
Check sledge guiding for proper adjustment.
Step 2.
(a) If out of adjustment, adjust sledge guiding,
(b) If malfunction persists, refer to direct/general support
maintenance.
5-36. MAINTENANCE PROCEDURES.
a. This section contains instructions covering organizational maintenance
functions for the paper cutter. Personnel required are listed only if the task
requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
