TM 5-3610-253-14
Install new brake pads and check air gap for clearance of 0.2 - 0.4 mm
g.
(.008 - .016 in.).
h.
If clearance is less than 0.2 mm (.008 in.), then remove brake pads and
sand pad surface until proper gap is obtained. Repeat steps g. and h. as
necessary.
i.
If clearance is more than 0.4 mm (.016 in.), remove brake pads and add
spacer foils until proper gap is obtained.
Remove the reset handles.
j.
k.
Rotate the safety plate left and cover the override holes.
l.
Remove main power knob and reinstall onto main power switch.
m.
Reinstall main motor V-belt cover.
n.
Place operator key back into safety lock.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS: Flat Tip Screwdriver
No. 2 Cross Tip Screwdriver
SUPPLIES: Overload Relay
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a.
Turn off power.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
(3) Using operator key, lock safety lock and keep key in your
5-420
