TM 5-3610-253-14
Table 5-19. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
UNDERCUT DURING THE CUT. THE KNIFE MOVES BACK INTO THE MATERIAL SO THAT THE TOP
SHEETS OF THE MATERIAL ARE LONGER - Cont
Step 1.
Check that material is properly jogged.
(a) If not, jog material.
(b) If jogged properly, proceed to step 2.
Step 2.
Check that material is not too soft for proper knife cut.
(a) Immaterial is too soft increase clamp pressure.
(b) If malfunction persists, refer to organizational maintenance.
5.
BOW OR HOLLOW CUT OBTAINED.
Step 1.
Check that material is properly jogged.
(a) If not, jog material.
(b) If jogged properly, proceed to step 2.
Step 2.
Check that material is not wavy or warped.
(a) Reduce the clamping pressure as far as possible and start
trimming the material from the center.
(b) If malfunction persists, refer to organizational maintenance
for replacement of the knife.
