TM 5-3610-253-14
Table 5-19. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. OVERCUT DURING THE CUT. THE KNIFE MOVES FORWARD IN THE MATERIAL SO THAT THE
LOWER SHEETS OF THE MATERIAL ARE LONGER - Cont
Check setting of clamp pressure adjustment knob.
Step 2.
(a) If it is below 1500, then increase clamp pressure by turning
clamp pressure adjustment knob to the right one or two
marks. Check again for overcut.
NOTE
Different materials require different clamp pressures. Refer to
(b) Repeat Step 2 until clamp pressure control knob has been
fully turned to the right.
(c) If malfunction persists, refer to organizational maintenance.
4. UNDERCUT DURING THE CUT. THE KNIFE MOVES BACK INTO THE MATERIAL SO THAT THE TOP
SHEETS OF THE MATERIAL ARE LONGER.
