TM 5-3610-253-14
Table 5-19. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
MACHINE DOES NOT CUT THROUGH MATERIAL - Cont
Check to make sure material being cut is not too hard.
Step 2.
(a) If material is too hard, do not attempt to cut material.
Equipment damage could occur.
(b) If malfunction persists, refer to organizational maintenance.
2.
BOTTOM SHEET OF MATERIAL IS CUT ONLY ON ONE SIDE OR NOT AT ALL.
Check cutting stick for deep cuts.
(a) If cutting stick has deep cuts, turn or exchange cutting
(b) If malfunction persists, refer to organizational maintenance
3. OVERCUT DURING THE CUT. THE KNIFE MOVES FORWARD IN THE MATERIAL SO THAT THE
LOWER SHEETS OF THE MATERIAL ARE LONGER.
Check that material is properly jogged.
Step 1.
(a) If not, jog material.
(b) If jogged properly, proceed to step 2.