TM 5-3610-253-14
(7)
Rotate manual knife change lever to cutting position.
(8)
Place a sheet of paper under the knife at both ends.
(9)
Press both cutting buttons and perform a cut.
If both pieces of paper were not cut, loosen locknuts on
(10)
turnbuckle and rotate turnbuckle 1/4 of a turn; then tighten
locknuts.
Turn off power.
aj.
(1)
Turn main power switch to 0 position.
Using operating key, lock the safety lock.
(2)
5-16.14 Replace Connecting Rod Shear Bolts.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: 12 mm Open End Wrench (2)
SUPPLIES: Shear Bolts
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a.
Turn off power.
(1) Turn main power switch to 0 position.
(2) Using operator key, lock safety lock and keep key in your
b. Remove eccentric cover.
5-171