TM 5-3610-253-14
(2) Using operator key, lock safety lock and keep key in your
b. To replace main power switch, proceed to step d.
c.
To replace control power on switch, proceed as follows:
(1) Remove four mounting screws holding control panel in place.
CAUTION
Main control panel is connected to paper cutter via a rod attached to
knife change lever. Panel cannot be pulled away from paper cutter more
than a few inches without damage to rod.
(2) Pull panel a few inches away from paper cutter and turn is so that
rear of control power on switch is visible.
(3) Remove heat shrink tubing from switch.
5-173
