TM 5-3610-253-14
Remove bolts and defective clutch pads and any spacer foils.
c.
d.
Install new clutch pads and secure with bolts.
e.
Check for air gap clearance of 0.40 - 0.8 mm (.016 - .031 in.).
f.
If clearance is less than 0.4 mm (.016 in.), remove clutch pads and sand
pad surface until proper gap is obtained when reinstalled. Repeat steps
d. through f. as necessary.
If clearance is more than 0.8 mm (.031 in.), remove clutch pads and add
g.
spacer foils until proper gap is obtained.
h. Reinstall main motor V-belt cover.
i.
Place operator key back into safety lock.
MOS: 83FJ6, Reproduction Equipment Repairer
Flat Tip Screwdriver
TOOLS:
Knife Reset Handles
13 mm Combination Wrench
Metric Feeler Gages (0.2 - 0.4 mm)
SUPPLIES: Clutch Brakes
Spacer Foils
Sandpaper, Medium Grit (Item 23, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a.
Turn off power.
5-141
