TM 5-3610-253-14
(1) Turn main power switch to 0 position.
(2) Using operator key, lock safety lock and keep key in your
b.
Remove main motor V-belt cover.
c.
Remove main power switch knob.
d.
Mount main power switch knob onto shaft of clutch pulley and rotate the
safety plate right to open the clutch override holes.
e.
Insert the reset handles into the override holes. Press the handles in
while rotating the pulley until the threads engage; then tighten the
handles.
f.
Remove bolts and defective brake pads and any spacer foils.
Install new brake pads and check air gap for clearance of O.20 - 0.40 mm
g.
(.008 - .016 in.).
h.
If clearance is less than 0.2 mm (.008 in.), remove brake pads and sand
pad surface until proper gap is obtained. Repeat steps g. and h. as
necessary.
5-142
