TM 5-3810-253-14
Table 5-8. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
20. PAPER CUTTER IS ON. MAIN MOTOR IS ON. LIGHT BARRIER SIGNAL LAMP IS OFF -
Cont
(1) Disconnect wiring to signal lamp.
(2) Press spring tabs and remove defective 1 amp from front
of housing.
(3) Install new signal lamp.
(4) Reconnect wiring.
(b) If signal 1 amp is not defective, proceed to step 5.
Step 3.
(a) If continuity is not present, replace fuse e7.
Check for 24 V input to relays d230a and b at plug connector
Step 4.
111, pin 1. Use pin 4 as ground.
5-130