TM 5-3610-253-14
Reinstall new bender bar and latch on the driver bar and reinstall
q.
driver.
NOTE
The following assemblies are installed as a single unit. Be sure to
engage the upper driving bar in the main shaft connecting link.
r.
Reinstall wire feed slide, upper driving bar, wire grip holder, driver
bar, and bender bar assemblies into left faceplate.
s.
Loosen upper faceplate screw and rotate faceplate down to line up screw
hole.
Reinstall lower faceplate screw and tighten both the upper and lower
t.
faceplate screws.
Reinstall headguard mounting pin in lower door hinge.
u.
v.
Return work table to flat work position.
w.
Reinstall work guide on work table.
Reinstall supporter spring rod in supporter.
x.
Manually rotate pulley to the right until stitcher head returns to the top
y.
of its stroke.
Rethread wire in stitcher head.
z.
Turn thickness adjustment handwheel to desired stock thickness.
aa.
ab.
Release pawl and manually rotate pulley to the right, observing stitcher
head for freedom of movement.
Close stitcher head door.
ac.
ad.
Reinstall stitcher headguard.
Reinstall rear belt guard.
ae.
Plug in power cord.
af.
3-54
