TM 5-3610-253-14
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: Flat Tip Screwdriver
SUPPLIES: Bender Bar
a.
Unplug power cord.
b.
Loosen screw on rear belt guard and remove guard.
c.
Remove stitcher headguard.
d.
Open stitcher head door.
e.
Rotate thickness adjustment handwheel fully to right.
f.
Unthread wire from stitcher head.
Release pawl and manually rotate pulley to the right until main shaft
g.
passes bottom of stroke and is one-fourth distance to top of next stroke.
h.
Pull supporter spring rod from supporter.
i.
Remove work guide from work table.
Move work table to saddle-stitch position.
j.
k.
Remove headguard mounting pins from lower door hinge.
l.
Remove lower screw from right faceplate and loosen upper screw.
NOTE
Hold wire feed slide in position.
3-52
