TM 5-3610-253-14
Release pawl and manually rotate pulley to the right until main shaft
g.
passes bottom of stroke and is one-fourth distance to top of next stroke.
h. Pull supporter spring rod from supporter.
i.
Remove work guide from work table.
Move work table to saddle stitch position.
j.
k. Remove headguard mounting pin from lower door hinge.
l.
Remove lower screw from right faceplate and loosen upper screw.
NOTE
Hold wire feed slide in position.
m.
Rotate right faceplate to horizontal position, and tighten upper screw
to hold faceplate.
3-49
