TM 5-3610-253-14
NOTE
The following assemblies are removed as a single unit. The upper driver
bar must be disengaged from the main shaft connecting link and the
supporter crank links must remain in their recessed position.
n.
The wire feed slide, upper driving bar, wire grip holder, driver bar,
and bender bar assemblies can now be removed from the left faceplate by
pulling them away from the left faceplate, and sliding them upward.
Remove driver with release pin.
o.
Remove driver bar latch from bender bar and replace with new latch.
p.
Reinstall bender bar and new latch on the driver bar, then reinstall
q.
driver.
3-50
