TM 5-3610-253-14
Remove drill bit.
g.
h. Lubricate spindle with silicone spray.
i.
Reinstall drift hole cover.
Reinstall drill bit by pushing into spindle.
j.
k. Clean excess lubricant from spindle and work surface.
l.
m.
Plug in power cord.
Lubricate drill bit with stick lubricant (Item 15,
Appendix E) as follows:
Turn power on.
a.
NOTE
Lubricate only sides and cutting edge of drill bit.
Hold end of stick lubricant against rotating drill bit.
b.
Drill through scrap paper to remove excess lubricant.
c.
Turn off power.
d.
TROUBLESHOOTING PROCEDURES.
a. The table lists the common malfunctions which you may find during operation
or maintenance of the paper drilling machine. You should perform the test/in-
spections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions. If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
2-22