TM 5-3610-253-14
(c) Check paper for proper drilling depth.
(d) Again, place single sheet of paper under drill bit.
(e) Place a 2 inch stack of scrap paper under the pressure foot, but
not under the drill bit.
(f) Push treadle down and check to be sure pressure foot holds the
stack firmly and the drill bit maintains the proper cutting depth.
(g) Check to be sure treadle does not contact frame.
d. Adjust Pressure Foot Clearance.
(1) Rotate flex locknut until pressure foot has 2 inch clearance from work
surface.
2-17
