ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039-12&P
3. Run the cable across the support bar towards the
starboard side of the aircraft.
Where the cable turns right, to run across the top
of the bar, place a wire tie.
Six inches from that point install another wire tie.
Where the cable bends to go forward, place
another wire tie.
4. Run the cable forward to the bar above the crew chief
seat.
5. Run the cable to the AC/DC power connectors on the
ceiling near the crew chiefs seat and connect
W116-1(P1) to J258 (Utility Receptacle-28VDC).
The W116-1 cable should be taut. Use additional
wire ties to remove any sagging wire.
Figure 2-31 Cable Tie Installation continued
(11) Installation is complete.
(12) Verify vehicle type is set to UH-60, paragraph 3-11b.
(13) Stow plumb bob arm.
(14) Secure helicopter doors.
2-34
