TM 5-6675-328-14
Table 7-4. TROUBLESHOOTING - Cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. HIGH METER READING WHILE CHARGING.
Step 1.
Check for reversed cable connections.
(a) If correct, proceed to step 2.
(b) If reversed, reconnect to proper terminals.
Step 2.
Check for shorted or dead battery cell.
(a) Replace battery.
(b) If battery still fails to charge, refer to direct/general
support maintenance.
7-10.
MAINTENANCE PROCEDURES. There are no operator maintenance procedures assigned for this equipment.
SECTION IV ORGANIZATIONAL MAINTENANCE
7-11.
LUBRICATION INSTRUCTIONS . This equipment does not require lubrication.
7-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND
SUPPORT EQUIPMENT.
7-12.1
Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
7-12.2
Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this manual.
7-12.3
Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-6675-328-
24P covering organizational maintenance of this equipment.
7-12
