TM 5-6675-328-14
SECTION V DIRECT/GENERAL SUPPORT MAINTENANCE
7-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND
SUPPORT EQUIPMENT.
7-18.1
Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
organization and Equipment (MTOE) applicable to your unit.
7-18.2
Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, IMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this manual.
7-18.3
Repair Parts. Repair parts are listed and illustrated in Repair Parts and Special Tools List, TM 5-6675-328-24P,
covering direct/general support maintenance for this equipment.
7-19.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a.
Direct/general support troubleshooting procedures cover the most common malfunctions that may be repaired at
the direct/general support level. Repair or adjustment requiring specialized equipment is not authorized unless such
equipment is available. Troubleshooting procedures used at lower levels should be conducted in addition to the
direct/general support troubleshooting procedures.
b.
This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If a
malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
c.
For unidentified malfunctions, use the following schematic or the foldout located at the end of this manual for
further fault analysis.
7-16
