TM 5-6675-325-14
NOTE
Calculator will print horizontal and true slope surface area of shape
last measured, followed by totals (added or subtracted) of horizontal
and true slope surface areas.
(6) Keeping foot switch depressed, reposition planimeter near shape to be
measured.
(7) Make next measurement.
(8) If change is made in planimeter function
Beg in
s.
Measuring areas without the calculator.
(1) Assemble QPS with planimeter.
(2) Activate QPS:
or if new scales or slope ratios
measurement procedures.
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
(b) Plug planimeter into E2encoder socket on back
(c) Plug power
auto-scaler.
(d) Plug power
(e) Plug power
(f) Plug power
transformer cable into POWER supply
transformer cable into wall outlet.
cord into back of calculator.
cord into wall outlet.
panel of auto-scaler.
jack on back panel of
(g) Set encoder OFF/E2/El switch on back of auto-scaler to E,.
(3)
(4)
(5)
5-6.21).
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i) Set auto-scaler B/ACCU/A/OFF switch to A.
(j) Set auto-scaler MAN/AUTO switch to MAN.
(k) Set auto-scalerXMEMORY switch to 1.
(1) Set calculator OFF/ON switch to OFF.
Tape map or drawing to be measured to table.
Select correct tracer arm length.
If needed, aline planimeter for tracer arm length selected (paragraph
Record TT value.
5-61
