TM 5-6675-325-14
(k) Set auto-scaler X MEMORY switch to 1.
(1) Set calculator OFF/ON switch to ON.
(m) Set calculator MAN/TRACE/NORM switch to NORM.
(n) Set calculator PRGM/RUN switch to RUN.
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6. 2h), Program 1, into
calculator.
(4) Tape drawing or map to remeasured to table.
(5) If needed, aline 1 i near measuring probe (paragraph 5-6.2.1).
(6) Record RL value.
NOTE
Factory determined RL value is given on Calibration Record Sheet
provided with equipment.
Alinement is performed as a check.
(7) Key in scale of map or drawing to measured.
q
and d if printout in feet and inches is desired.
Linear measur
straightedge.
NOTE
ing probe stand is used to facilitate measurement using a
(9) If needed, mount linear measuring probe in stand.
(10) Press CLEAR button to clear auto-scaler.
(11) Press foot switch.
Do not release until ready to begin measurement.
(12) Position linear measuring probe so that pricking pin is at beginning of
length to be measured. Release foot switch.
5-64
