TM 5-6675-325-14
(2) Activate QPS:
(a) Plug foot switch into CLEAR input jack on back panel of auto-scaler.
(b) Plug remote tracer switch into ACCU input jack on back panel of
auto-scaler.
(c) Plug 1 i near measuring probe into El, encoder socket on back panel of
auto-scaler.
(d) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(e) Plug power transformer cable into wall outlet.
(f) Plug power cord into back of calculator.
(g) plug power cord into wall outlet.
(h) Set
(i) Set
(j) Set
(k) Set
(1) Set
(m) Set
(n) Set
(o) Set
encoder 0FF/E2/E1 switch on back panel of auto-scaler to El.
AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
auto-scaler B/ACCU/A/OFF switch to A.
auto-scaler MAN/AUTO switch to AUTO.
auto-scaler X MEMORY switch to 1.
calculator OFF/ON switch to ON.
calculator MAN/TRACE/NORM switch to NORM.
calculator PRGM/RUN switch to RUN.
(3) Tape piece of paper to table.
(4) Draw line exactly 10 inches long.
(5) Label ends of line A and B.
NOTE
Foot switch must remain depressed until ready to begin measurement, so
that movement and handling of linear measuring probe will not increment
counter.
(6) Press CLEAR button on auto-scaler.
(7) Depress foot switch to initiate ACCU and freeze count at zero.
5-53
