TM 5-6675-325-14
(4) Use printout to verify program, and load magnetic card.
k. Recording program on magnetic card.
(1)
(2)
(3)
key.
(4)
Manually enter desired program into calculator memory (paragraph 5-6.2i).
Obtain printout to verify program.
NOTE
If printout does not verify program, repeat steps (1) and (2).
Set PRGM/RUN switch to PRGM.
If display does not show 000 or 001, press
Select unclipped and unmarked magnetic card from packet of cards.
CAUTION
magnetic card by the edge. Be sure hands are clean. Grease. oil.
Hold
and other materials can damage magnetic card.
,
,
l
Do not continue to hold card after it is grapsed by feed mechanism. Damage
to magnetic card may occur.
(5) Load side one of magnetic card through reader. If display indicates
ERROR, press any key to clear.
(6) Pass side one through reader again.
If calculator displays Crd, reverse
card and load side two.
(7) Print out program to verify.
(8) Mark magnetic card to identify program.
(9) To protect contents of magnetic card from being erased, cut corners of
card along notches.
5-49