TM 5-6675-323-14
(2) Activate QPS:
(a)
P l u g foot switch into CLEAR input jack on back panel of auto-scaler.
(b)
Plug r e m o t e t r a c e r s w i t c h i n t o A C C U i n p u t j a c k o n b a c k p a n e l o f
auto-scaler.
Plug l i n e a r m e a s u r i n g p r o b e i n t o E1 , e n c o d e r s o c k e t o n b a c k p a n e l o f
(c)
auto-scaler.
(d)
Plug p o w e r transformer cable into POWER supply jack on back panel of
auto-scaler.
(e)
Plug p o w e r t r a n s f o r m e r c a b l e i n t o w a l l o u t l e t .
Plug p o w e r c o r d i n t o b a c k o f c a l c u l a t o r .
(f)
Plug p o w e r c o r d i n t o w a l l o u t l e t .
(g)
(h)
Set e n c o d e r
0 F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o E1 .
(i)
S e t A U D I O / O F F switch on back panel of auto-scaler to AUDIO.
S e t a u t o - s c a l e r B/ACCU/A/OFF switch to A.
(j)
(k)
S e t auto-scaler MAN/AUTO switch to AUTO.
(l)
S e t a u t o - s c a l e r X MEMORY switch to 1.
(m)
S e t c a l c u l a t o r OFF/ON switch to ON.
(n)
S e t calculator MAN/TRACE/NORM switch to NORM.
Set c a l c u l a t o r PRGM/RUN switch to RUN.
(o)
Press
following
keys:
(P)
(3)
Tape piece of paper to table.
(4) Draw line exactly 10 inches long.
(5) Label ends of line A and B.
NOTE
F o o t switch must remain depressed until ready to begin measurement, so
that movement and handling of linear measuring probe will not increment
counter.
(6) Press CLEAR button on auto-scaler. .
(7) Depress foot switch to initiate ACCU and freeze count at zero.
9-53
