TM 5-6675-323-14
o.
Measuring areas with planimeter.
( 1 ) Assemble QPS with planimeter.
(2) Activate QPS.
P l u g f o o t switch into PRINT input jack on back p a n e l
(a)
of
auto-scaler.
P l u g r e m o t e tracer switch into ACCU input jack o n b a c k p a n e l o f
(b)
auto-scaler.
P l u g p l a n i m e t e r i n t o E2 e n c o d e r s o c k e t o n b a c k p a n e l
(c)
of
auto-scaler.
Plug p o w e r transformer cable i n t o power supply j a c k o n b a c k p a n e l o f
(d)
auto-scaler.
P l u g p o w e r transformer cable i n t o w a l l o u t l e t .
(e)
Plug p o w e r c o r d i n t o b a c k o f c a l c u l a t o r .
(f)
Plug p o w e r c o r d i n t o w a l l o u t l e t .
(g)
Set e n c o d e r
(h)
O F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o E2 .
S e t A U D I O / O F F switch on back panel of auto-scaler to AUDIO.
(i)
S e t a u t o - s c a l e r B/ACCU/A/OFF switch to A.
(j)
(k)
S e t auto-scaler MAN/AUTO switch to MAN.
S e t auto-scaler X MEMORY to 1.
(1)
S e t c a l c u l a t o r OFF/ON to ON.
(m)
S e t calculator MAN/TRACE/NORM switch to NORM.
(n)
S e t PRGM/RUN switch to RUN.
(o)
(p) Press following keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
o t h e r materials may damage magnetic cards.
( 3 ) Load preprogrammed magnetic card (paragraph 9-6.2h), Program I, into
calculator.
(4) Tape map or drawing to be measured to table.
(5) Select correct tracer arm length.
9-55
