TM 5-6675-323-14
(P)
Press
following
keys:
(3) Set up planimeter for area measurement (paragraph 9-6.20).
(4) To add areas being measured, in square feet or square feet and acres,
press
.
(5) Reposition planimeter near next shape to be measured. Keep remote tracer
switch depressed.
(6) Clear auto-scaler by pressing CLEAR button.
(7) Trace boundary line of shape using dot on lens tracing assembly. Stop
when you reach starting point.
(8) Press foot switch to activate print command.
NOTE
Calculator will print data on area just measured. It prints area of
single shape in square feet first, followed by area in square feet and
Current total areas are printed in same order.
acres.
(9) If area is to be subtracted instead of added, press
and c f o r
Actuate routine.
R e p e a t measurement procedure.
Measuring surface area of slope.
q.
( 1 ) Assemble QPS with planimeter.
(2) Activate QPS:
(a) Plug foot switch into PRINT input jack on back panel of auto-scaler.
(b) Plug remote tracer switch into ACCU input jack on back panel of
auto-scaler.
( c ) P l u g p l a n i m e t e r i n t o E2 e n c o d e r s o c k e t o n b a c k p a n e l o f a u t o - s c a l e r .
(d) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(e) Plug power transformer cable into wall outlet.
(f) Plug power cord into back of calculator.
(g) Plug power cord into wall outlet.
( h ) S e t e n c o d e r 0 F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o E2 .
(i) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
9-58
