TM 5-6675-323-14
Table 3-22. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
COMPUTER DISPLAYS ERROR MESSAGE.
2.
PLOTTER STOPS .
Refer to Table 3-21, Plotter Operation and Program Errors, for corrective
procedure.
(a) Re-enter program using correct key sequence.
(b)
If problem persists,
refer
to
direct/general
support
maintenance.
EVERYTHING ELSE IS INOPERATIVE.
COOLING FAN RUNS.
3.
Press LINE power switch to off (0) and then to on (I).
NOTE
T h i s action resets power supply if fault was caused by momentary low line
voltage.
If problem persists, refer to direct/general support maintenance.
4. PLATEN DOES NOT HOLD PAPER WHEN "CHART HOLD" IS ACTIVATED.
S t e p 1.
Check that paper is not wet and platen is clean.
(a) If paper is not wet and platen is clean, proceed to
Step 2.
(b) Clean platen if necessary.
(c)
Replace
paper.
S t e p 2.
Press LINE power switch to off (0) and then to on (I).
If problem persists, refer to direct/general support maintenance.
3-218
