TM 5-6675-323-14
Table 3-22. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
13. PLOTTER WILL NOT RESPOND TO DIGITIZE COMMAND OR TRANSFER COORDINATES.
S t e p 1.
Check that LISTEN ONLY switch is set to 0 (talk and listen) mode.
(a) If not, set LISTEN ONLY switch to 0.
(b) If correct, proceed to step 2.
S t e p 2.
C h e c k to see if ERROR or OUT OF LIMIT lamp on front panel is lit.
(a) If lit, enter correct error in program syntax.
(b) If problem persists, proceed to step 3.
S t e p 3.
Perform operator's HP-IB operational test (paragraph 3-14.2).
If problem persists, refer equipment to direct/general support
troubleshooting.
3 - 1 9 . MAINTENANCE PROCEDURES. There are no operator maintenance procedures
assigned for this equipment.
3-221
