TM 5-6675-323-14
3-15.4
Operating
Instructions
on
Decals
and
Instruction
Plates.
3 - 1 6 . OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation
only in a controlled environment.
Section VIII OPERATOR MAINTENANCE
3-17.
L U B R I C A T I O N I N S T R U C T I O N S . This equipment does not require lubrication.
3-18. TROUBLESHOOTING PROCEDURES.
a . T h e table lists the common malfunctions which you may find during operation
or maintenance of the X-Y graphics plotter, or its components. You should perform
the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
Prior to proceeding with equipment troubleshooting perform the following
c.
steps:
(1) Check that power cable is connected.
(2) Check that all switches are in proper positions for normal operation.
3-214
