TM 5-6675-323-14
Table 3-22. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NO MOVEMENT IN "Y" DIRECTION.
8.
Refer plotter to direct/general support
Problem is not operator correctable.
troubleshooting.
9.
PLOTTER INITIALIZES, THEN CONTINUES TO DRIVE, WHILE IN (LOWER RIGHT) STOPS.
Refer plotter to direct/general support
Problem is not operator correctable.
troubleshooting.
10. PEN SKIPS WHILE PLOTTING.
Refer
to
direct/general
support
Problem is not operator correctable.
troubleshooting.
11. PLOTTER PERFORMS ABNORMALLY OR ERRATICALLY.
Refer
to
direct/general
support
Problem is not operator correctable.
troubleshooting.
12. PLOTTER DOES NOT DRAW EXPECTED PLOT OR PLOT APPEARS INACCURATE.
S t e p 1.
Check program for incorrect or misplaced syntax.
(a) If program is correct, proceed to step 2.
( b ) Re-enter correct program sequence.
Perform operator's HP-IB operational test (paragraph 3-14.2).
S t e p 2.
If problem persists, refer plotter to direct/general support
troubleshooting.
3-220
