TM 5-6675-319-14
(d) Close and latch lens box.
(e) Turn on NEGATIVE CARRIER switch.
( f ) A d j u s t p o s i t i o n o f n e g a t i v e b y l e a d e r u n t i l p r o j e c t e d i m a g e is
centered in cutout area on print stage.
(g) Turn off NEGATIVE CARRIER switch.
(h) Close lower cabinet door.
(i) Set MODE switch to AUTO.
(j) Set % DODGING control to MAX.
(k) Set % CHANGE switch to 0.
(l) Obtain several pieces of printing material to be used (cut sheets
or several pieces of roll paper) that are a little larger than mask cutout .
(m) Place printing material (emulsion side down) over mask cutout.
(n) Lower and lock printer hood.
NOTE
Exposure light glows during exposure and is extinguished when exposure is
complete.
(o) When exposure is complete, unlock and open hood.
(p) Remove and process exposed printing material.
(q) If processed print is too light, increase EXPOSURE INDEX switch
setting and if processed print is too dark, decrease EXPOSURE INDEX switch setting;
repeat steps (m) through (p) above.
(r) When desired exposure is obtained, proceed to step (26) .
(26) Open lower cabinet door.
(27) Unlatch and open lens box.
(28) Remove test negative from printer.
( 2 9 ) N e g a t i v e p o s i t i o n i n g.
(a) If negative to be copied is in cut form, center cut negative
(emulsion side up), on negative carrier. Then proceed to step (30).
9-45
